SiC Silicon Carbide Elements G Type 3.5kW Grade 1600 SiC Heater

G Type SiC Heating Elements

Instructions for using silicon carbide rods

(1) After being heated in the air, the silicon carbide rod forms a dense silicon oxide film on its surface, which becomes an antioxidant protective film and prolongs its lifespan. In recent years, various coatings have been developed to prevent cracking of silicon carbide rods for use in furnaces with various gases.

(2) The larger the current applied to the silicon carbide rod, the higher the surface temperature of the silicon carbide rod. Suggest using the lowest possible surface load density (power). Please note that the values recorded on the cold end of the silicon carbide rod are the current and voltage at 1000 ℃ in the air, which may not necessarily match the actual use. In general, the surface power of silicon carbide rods is determined by the relationship between the temperature inside the furnace and the surface temperature of the silicon carbide rods. It is recommended to use a surface power value of 1/2-1/3 of the ultimate density of the silicon carbide rods (W/cm2)

(3) When using silicon carbide rods continuously, it is desirable to slowly increase the resistance to maintain a long lifespan.

(4) Silicon carbon rods should be connected in parallel as much as possible. If the resistance values of silicon carbide rods are different, the high resistance silicon carbide rods in series will concentrate the load, causing a rapid increase in the resistance of one silicon carbide rod and a shorter lifespan

(5) The temperature distribution characteristics of silicon carbide rods require a specification of within Δ 60 ℃ of the effective heating length for inspection upon new shipment. However, the temperature distribution may increase with aging and may eventually reach 200 ℃. The specific temperature distribution changes also vary depending on the furnace atmosphere and usage conditions.

(6) Silicon carbon rods have a shorter lifespan as the usage temperature increases. Therefore, after the furnace temperature exceeds 1400 ℃, the oxidation rate accelerates and the lifespan is shortened. During use, it is important to avoid excessively high surface temperatures on the silicon carbon rods.

sic silicon carbide elements

silicon carbide elements g type

grade 1600 sic heater

SiC Silicon Carbide Elements G Type 3.5kW Grade 1600 SiC Heater Images